How do I get my Pontiac out of theft mode?

To disable the system and start your car, use the following steps.

1. Step 1: Check the anti-theft light.
2. Step 2: Turn on the ignition.
3. Step 3: Do a secondary check on the anti-theft light.
4. Step 4: Try starting the car fully.
5. Step 5: Repeat this process.

How do you reset the security on a Pontiac Grand Am?

Turn the key to the on position for 10 minutes then turn off, repeat 2 more times. the system should reset.

How do you reset the anti-theft system on a 1996 Pontiac Grand Am?

How do i reset security code?

1. Perform a security system relearn.
2. Let the vehicle sit for more than 10 minutes with the key off.
3. Attempt to start the engine, leave the key in the run position monitoring the security system indicator.
4. After 10 minutes, the security indicator will change state.

How do I reset my passlock security system?

How to Reset the Passlock System on GM Cars

1. Insert your key in the starter, start you car as you usually would and let it stall. Keep the key in the “On” position.
2. Wait until the “Theft Sys” light on your dashboard stays on without blinking. This will take approximately 10 to 15 minutes.

How do I reset my car alarm after changing the battery?

If the light turns off as usual once the car is started, then the system should be properly reset without any issues. You typically will not need to do anything to reset your car alarm after a battery change, but it should automatically reset for you.

Can you disable passlock?

The easiest way to bypass the Passlock 2 system is to place a resistor between the passlock sensing wire and the ground reference wire. To find these wires, look for three wires that at some point are wrapped together, coming from the ignition barrel. Usually, they are orange/black, red/white, and black.

How do I reset my GM security system?

How do you reset the Chevy Silverado’s anti-theft system? Insert the ignition key, put it in the on position, attempt to start the engine. With the key in that position, wait ten minutes. The security light will blink and go out.

What is immobilizer PIN code?

The PIN code is a combination of buttons that you need to press after getting behind the wheel. If the correct combination isn’t provided, Stealth Immobiliser doesn’t allow the engine to start, essentially making it impossible for the car to be stolen.

How do I reset my electronic immobilizer?

Hold the panic button for five seconds to reset the immobilizer. Then press the lock button twice and wait ten meters from the car for ten minutes.

How do I unlock my immobiliser?

To reset the immobilizer, hold down the panic button. Wait for ten minutes if you push the lock button two times.

How do I reset my GM anti-theft system?

Where is PASSLock sensor located?

the passlock iii system uses a transponder located under the plastic covering of the key. in most cases, these keys are stamped “pk3” on the metal blade near the plastic covering.

How do I relearn a GM PASSLock?

To perform a relearn on a Passlock system, make sure there is a fully charged battery in the vehicle. The battery will be used for 30 minutes without the alternator available for charging. Connect a battery charger to the battery to ensure power is available while programming.