Is the Fox 36 a good fork?
Is the Fox 36 a good fork?
Conclusion. On the trail, the FOX 36 Factory feels, well, like a FOX 36. It’s a fork at the very top of its game. The GRIP2 damper gives huge control over the rebound and compression circuits with both high- and low-speed adjustment and once dialled in, grip and support are exceptional.
How much air should I put in my Fox 36?
Generally, sag should be set to 15 – 25% of total fork travel….Setting Sag.
| 36 float AIR SPRING SETTING guidelines | |
|---|---|
| Rider Weight | Air Pressure |
| 200 – 215 lbs. | 76 psi |
| 215 – 230 lbs | 83 psi |
| 230 – 250 lbs. | 90 psi |
How often should FOX Shocks be serviced?
Fox Suspension Service Fox recommends that the minimum suspension fork and shock service is 125 hours of use, yearly, or whichever comes first. That is certainly on the longer side of things.
Can you increase travel on Fox 36 fork?
2018 36mm FLOAT forks can be travel adjusted by replacing the air shaft assembly. 36mm FLOAT NA2 forks can be reduced in travel as low as 100mm (831 air shaft). Certain 36mm FLOAT forks may have their tavel extended only if they were built with a damper that can be extended safely to the new longer travel.
How often should FOX forks be serviced?
Fox Suspension Service Fox recommends that the minimum suspension fork and shock service is 125 hours of use, yearly, or whichever comes first.
Can I use WD40 on my bike suspension?
Please don’t use WD40, GT85 or any similar products! Instead of cleaning your seals, they will wash away the grease under the seals, letting dirt in much more easily– even if you’re careful you will also risk contamination of brake rotors/pads and these products can also dry out seals.
How much air should I put in my Fox Float shock?
~50 psi
Check that no part of your shock contacts any portion of your frame or linkage as it cycles through its travel. Add air pressure to the main air chamber in ~50 psi (3.4 bar) increments, slowly cycling the shock after every 50 psi (3.4 bar) addition.
How do you soften Fox shocks?
When you decrease rebound damping by turning the adjustment knob counter-clockwise, you allow the shock to extend faster. It feels softer, more supple, and livelier. When you increase rebound damping by turning the adjustment knob clockwise, you make the shock extend slower.
How often should you service FOX 36?
How often should FOX shocks be serviced?
How do I increase travel on Fox 36?
How do you adjust a Fox 36 fork?
Use your air pressure to find your rebound setting. Turn your rebound knob to the closed position, clockwise until it stops. Then turn it counter-clockwise to the number of clicks shown in the table below. Rebound controls the rate of speed at which the fork extends after compressing.
How much does a FOX fork service cost?
$190 USD
$190 USD • $220 CAD* Thorough inspection of fork for wear and/or damage. Complete teardown and rebuild of damper, including new seals and oil. New dust wipers and foam rings.
