How do I reset my Cisco wireless Router?

The default username is cisco and the default password is cisco. Step 1. Press the Reset button located at the back of the device with a pin for approximately 15 seconds or until the power light on the front of the device starts flashing. The Router reloads and is set to the default configuration settings.

How do I Reset my Cisco Aironet 1100?

1 Answer

1. Step 1 Disconnect power from access point.
2. Step 2 Press and hold MODE button while you reconnect power to the access point.
3. Step 3 Hold the MODE button until the status LED turns amber, and release the button.

What is the default password for Cisco Aironet AP?

Cisco
The default password is Cisco.

How do you Reset your router to factory settings?

How to Reset Router From Configuration Page

1. Type your router’s IP address into any web browser’s search field.
2. Enter your username and password when prompted.
3. Go to System or System Tools.
4. Look for Restore or Factory Default.
5. Click Restore or Reset and OK to confirm.
6. Wait for the router to reboot.

How do you Reset a cisco switch physically?

Hold the “mode” button on the front of the switch for 10 seconds. The lights will blink then go solid – the switch completely wipes all configuration and then reboots.

How do you Reset a switch?

How to Perform a Hard Reset (Factory Reset) on a Nintendo Switch

1. With the system powered down, hold the power button until the console resets. This step can take up to 15 seconds.
2. Release the power button, then press it once to start the console like normal.
3. Your console should boot up without any issue.

How do I log into my Cisco Aironet?

Type 10.10. 10.1 (the default IP to access the admin interface) in the address bar of your internet browser to access the router’s web-based user interface. You should see 2 text fields where you can enter a username and a password. The default username for your CISCO Aironet 1200 is Cisco.

Where can I find a troubleshooting guide for the Cisco Aironet 1130ag series?

Before contacting Cisco, look for a solution to your problem in this guide or the troubleshooting chapter of the Cisco Aironet 1130AG Series Access Point Hardware Installation Guide. The Technical Assistance Center (TAC) maintains a list of top wireless technology issues on Cisco.com at the following link:

Where can I find the declarations of compliance for the Aironet 1130ag?

The Declarations of Compliance for this product relevant to the European Union and other countries following EU Directive 1999/5/EC (RTE Directive) can be found in the Cisco Aironet 1130AG Series Access Point Hardware Installation Guide. This guide is available on Cisco.com.

What is the primary configuration tool for Cisco Aironet?

The GUI is the primary-configuration tool. Configuration can also be performed using the command line interface (CLI). For instructions on using the CLI, see the Cisco IOS Software Configuration Guide for Cisco Aironet Access Points.

How do I mount the 1130ag series access point on the ceiling?

When mounting the access point on a hard ceiling, use four fasteners capable of maintaining a minimum pullout force of 20 lbs (9 kg). Connect the 1130AG series access point to a power source. The access point can be powered locally by using an AC power module or over the Ethernet using power sourcing equipment (PSE).