Does Delta still make bandsaws?

Delta 100 Year Anniversary Delta manufactures quality woodworking machinery you can count on. From band saws to table saws, Delta has always considered the woodworker in our design and manufacturing of our equipment.

How much tension should a bandsaw blade be?

Finding the right tension Most blade manufacturers recommend 15,000 psi to 20,000 psi for a common carbon-steel blade. However, bimetal, spring-steel, and carbide-tipped blades are much stronger than carbon-steel blades, so manufacturers recommend a much higher tension: 25,000 psi to 30,000 psi.

How much does a 14 inch bandsaw weigh?

167.2 lb. 24-1/2 in.

How long is a 14 bandsaw blade?

93-1/2″
Olson® All Pro™ band saw blades 93-1/2″ length fits most 14″ band saws (Delta, Jet, etc.), hard back and exclusive material, in skip, hook, or regular teeth.

How tight should a bandsaw blade be?

What are three 3 safety rules to follow when using the bandsaw?

Safety Rules Safety glasses are required. Never clear small pieces while blade is moving. Never adjust saw or setup while saw is running. Never cross arms.

Why won’t my bandsaw cut straight?

When diagnosing a machine that is not cutting straight look at the guides. If the rear guide is touching the blade even when not cutting, then the rear guide is probably set too far forwards. This is forcing the blade forward of its natural position on the blade wheels and can cause poor quality cuts.

Why does my sawmill cut wavy?

If the cutting rate is not enough the surface looks like goose bumps. If the cutting rate is too high then the blade has no time to make a cut and therefore “wavy” cuts appear. Special attention should be paid to sawmill alignment. Very often, even experienced operators don’t pay due attention to the sawmill condition.

What is the model number for a delta band saw?

INSTRUCTION MANUAL DATED 1-15-96 PART NO. 426-02-651-0023 ©Delta International Machinery Corp. 1996 14″ Wood Cutting Band Saw (Model 28-280) The Serial No./Model No. plate is attached to the right side of the base casting.

How do I adjust the table on my band saw?

The table on your band saw can be tilted 45 degrees to the right and 10 degrees to the left. To tilt the table, loosen the two lock knobs (A) Fig. 15, tilt the table to the desired angle and tighten the two lock knobs (A). ADJUSTING TABLE STOP

Where can I get my Delta Machine or accessories serviced?

All Delta Machines and accessories are manufactured to high quality standards and are serviced by a networkof Porter-Cable• Delta Factory Service Centers and Delta Authorized Service Stations.

How do you set the support bearing on a miter saw?

The upper blade support bearing (E) Fig. 55 preventsdamage to the set in the saw teeth by keeping the bladefrom being pushed too far toward the back. The supportbearing (E) should be set 1/64″ behind the blade byloosening the thumb screw (F) and turning the knurledknob (G) to move the support bearing (E) in or out.