Can you replace a T12 lamp with a T8 lamp?

The easiest and lowest price option to replace a T12 is a T8 linear fluorescent. They have become the go-to option for pre-existing T12s. If you still have magnetic ballasts, switching to a T8 will require a ballast swap. Another option is to move forward with an LED retrofit.

Can you convert T12 to T8 LED?

T8 LED lamps which are not direct-wire compatible (with ballast) will require a T8 ballast to operate, so unless the T12 ballast in the T12 fixture is replaced with a T8 ballast, a non-direct-wire compatible T8 LED lamp will not work in a T12 fixture.

How do you convert a T12 fluorescent light to a fixture?

3 steps to retrofit from T12 to LED

1. Set goals.
2. Build a budget.
3. Know your T12 replacement options.
4. A. Install a direct wire or ballast-bypass linear LED lamp.
5. B. Install magnetic and electronic ballast-compatible linear LEDs.
6. C. Install electronic ballast-compatible linear LEDs and a new electronic ballast.
7. D.
8. E.

Should I bypass ballast for LED lights?

An LED light does not require a ballast because it uses a component called a “driver” to regulate the power going into the bulb.

Will a T12 socket work for a T8 lamp?

The lamp sockets will work for both T12 and T8 lamps because the pin configuration is the same. If a socket has signs of wear or if it is cracked or broken then the socket should be replaced.

What is a T8 bulb conversion kit?

Converts (1) 8 foot T8 or T12 fluorescent strip light fixtures into an energy efficient T8 LED light fixture. This kit comes pre-wired for easy installation. This Orilis Conversion Kit converts (1) 8 ft 2-light single pin fluorescent fixture to accept (4) 4 ft LED tubes. Kit will only accommodate fixture housings between 4.25″ and 5″ wide.

How do you install a T8 bulb in a ballast?

Connect the line voltage wires that supply power to the fixture to the ballast with wire nuts and ground the fixture. Refer to the schematic on the ballast and the instructions provided by the manufacturer of your kit. Reinstall the ballast cover and install new T8 bulbs. Reinstall the lens cover, if applicable.

What is the difference between F40 T12 and F96 T12?

The circuit voltage. F40T12 – 4 foot length. F96T12 – 8 foot length. NOTE: The lamps will be replaced with new T8 lamps as specified on the new T8 Ballast. The number of lamps. Refer to the following example which describes the basic conversion process.