What are the positions on a sand filter?
What are the positions on a sand filter?
The FILTER Position: On sand filters, water enters at the top of the tank, and for DE filters, water enters at the bottom of the tank. After passing through the filter media, the water exits the tank again into the multiport valve, leaving through the “RETURN” port, and back to your pool.
When Shocking a pool should the pump be on filter or recirculate?
The Filter setting is the best setting or filter position to use after shocking your pool. You may also use the Recirculate setting on your filter.
How full should my pool sand filter be?
Sand filters are not filled completely full of sand, but only about 2/3 full, to allow “Freeboard” space in the tank, above the sand bed.
Do you use chlorine tablets with a sand filter?
You don’t put chlorine tablets in a sand filter because they’re supposed to go in a chlorine float. You can also add liquid or powder chlorine to the water. Either way, make sure you’re applying it by slowly walking around the outer edge of the pool while the pump is on.
How do I prime my pool pump when I open it?
Steps to Prime Your Pool Pump
- Turn off the pump.
- Switch to recirculate.
- Release air.
- Clean out the pump basket.
- Fill the pump basket.
- Once the pump basket is filled and tightened, make sure the air release valve is open and turn the power to the pump on.
- Check the water flow to your pump.
How much sand does a Intex sand filter hold?
Intex sand filter pumps come in two sizes. The smaller 1,600 gph model uses a 0.5 horsepower motor and a 14″ tank which holds about 55 pounds of sand. The 2,650 gph models uses a 0.95 horsepower motor and a 16″ tank which holds about 100 pounds of sand.
How do you set up an Intex saltwater pool filter?
Setting Up Your Intex Saltwater Filter System. Turn on the machine. Plug the power cord into an electrical outlet. And turn on the unit. With the filter pump turned on and operating. Set the operating hours for your saltwater system. Each pool size has different required operating hours. You can refer to your Intex pool pump manual for this one.
Do I need help with my Intex pool pump setup?
If you need assistance for your Intex pool pump setup, then follow these instructions. The first step is to grab a Phillips screwdriver. You’ll be needing that later. Ask for assistance from one of your family members or friends. At least two people should work on your Intex pool pump setup.
How to add sand to a pool filter?
Make sure you place the sand shield over the top of your filter’s center pipe. You must only fill it halfway. And to evenly distribute the sand inside the tank. Once you add the sand in, you can now put the 6-way valve on the center pipe hub top opening. Place an L-shape O-ring on the 6-way valve inlet connection and the pump motor outlet.
