How much does it cost to have axle seals replaced?
How much does it cost to have axle seals replaced?
Fixing an axle seal can cost anywhere from $150 to several hundred dollars, depending on the make and model of your car. If you detect a leak it’s better to fix it sooner rather than later, as ruining your transmission is an expensive repair.
How do you pull the axles out of a Ford 9 inch rear end?
How to Disassemble Ford 9 Inch Axles: Brake Drum and Axle Shafts
- Step-1: Loosen Nuts.
- Step-2: Remove Nuts.
- Step-3: Loosen Axle Shaft Plate.
- Step-4: Remove Axle Shaft (Special Tool)
- Step-5: Remove Brake Backing Plates.
- Step-6: Seal Inside of Housing.
- Step-7: Remove Retainer Ring.
How long can you drive with a leaking axle seal?
If there is significant fluid loss, so much that it affects the transmission, the vehicle should not be driven. If the leak is small and you can’t make it to an appointment for a few days, it is okay to drive your vehicle as long as you keep the transmission fluid full.
How are bearing seals measured?
Bearings and seals are generally measured in inches. It is best to use a digital caliper, like # PTW80157, and measure out to 3 decimal places to find the most precise figure. I’ve attached an image that shows how to measure and identify them. As well as a help article on replacing them that may be helpful to you.
How long can you drive with axle seal leak?
If your vehicle has a small axle seal leak, it may be okay to continue driving for now, but you should look to have your car’s axle shaft inspected and potentially replaced immediately. Make sure to keep your transmission fluid full so your transmission keeps running smoothly.
What happens if you don’t fix an axle seal leak?
If the leaking axle seal does not get fixed soon and the transmission is slipping, you could cause permanent damage to the transmission.
What causes a rear pinion seal to leak?
Wear & Tear: The most common cause of a rear differential pinion seal leak is wear and tear. Over time, the pinion seal wears and can become dry, cracked, or otherwise damaged, allowing fluid to leak out due to pinion bearing preload.
What is the diameter of a Ford axle bearing?
Axle Bearings, 1.377 in. Bore Diameter, 2.835 in. O.D., Ford 8 in., Ford 9 in., Each Axle Bearing, 3.150 in. O.D., Ford, 9 in.,
How big are the seals on a Ford axle?
Axle Housing Seal, Ford 9 in., Each Axle Snout Seal, Rear Outer, Ford 9 in., Each Axle Seal, Mighty, Conversion Seal, Rear, Ford 9 in., Each Inner Seal, Replacement, Aluminum Axle Housing Seal, Steel/Rubber, 1.125 in. I.D.,
What year did the Big bearing axle come out?
The big bearing axle typically came on trucks and full size ford cars found in the late 50’s. We pulled a 9 inch rear housing out of a ’59 Ford Edsel that had the large bearing ends on it, just as an example.
Will a 9 inch rear axle seal fit a 31 spline axle?
We pulled a 9 inch rear housing out of a ’59 Ford Edsel that had the large bearing ends on it, just as an example. (Yes, it looks quite ugly) This is the correct seal for our SMALL bearing 9 inch or 8 inch with 28 spline axles. It will fit 31 spline axles, just be careful with installing the thicker axles as they can damage the seal.
