How tight should a slip clutch be?

The maximum tight setting for the slipper is just at the point where there is little or no tire slippage on a high traction surface such as carpet or a prepared racetrack. The slipper should not be tightened to the point that clutch slippage is completely eliminated.

Is a bush hog supposed to be level?

When hooking up and leveling your rotary cutter, most people think that from front to back, a rotary deck should be level which is not the case. The front should be set slightly lower, about half an inch to an inch, depending on the thickness and height of the overgrowth.

How often do you grease a bush hog?

The rotary cutter’s driveline should be greased with every eight (8) hours of use (this includes the inner shaft as well as U-joints, and shield bearings). Make sure to lubricate all driveline slip joints, U-joint crosses, and the center of driveline CV joint (if applicable).

What happens if you over tighten slipper clutch?

Setting Your Slipper Clutch The process of setting the slipper clutch to work properly seems easy, but most people still don’t have a clue how to do it. Too much slip and you can overheat the slipper; too tight and you can do damage to the spur gear (or the gears inside the transmission).

Why is my slip clutch smoking?

If the slip clutch springs are too loose your friction plates will slip. You could notice ‘smoke’ coming from the slip clutch. If this in the case you need to adjust the bolts on the slip clutch by tightening them a further 1/2 revolution.

How does a 2 stage tractor clutch work?

Any tractor that has a power takeoff assembly generally has a two-stage clutch. A two-stage clutch allows you to engage the clutch to change gears without disengaging the PTO drive. The mower or other machinery operated by your PTO will disengage only when the clutch is pressed completely down.

How do you adjust PTO pressure?

Adjust the pressure by turning the valve stem with allen wrench in the hole through the spool. Screw stem up into block for more pressure and thread it down or out of block for less pressure. Do not exceed 300 PSI or you’ll damage to clutch pack.

Can you brush hog when it’s wet?

Usually, brush hogging over wet grass will not cause the blades on the rough cut mower to become dull more quickly than when cutting on dry ground.

Should brush hog blades be sharp?

You should sharpen your bush hog blades whenever you notice the bush hog is not cutting properly, or becoming heavily clogged with torn debris. A dull blade will pull tough stalks instead of cutting them, and they could wrap around the output shaft of the gearbox and ruin the seal in the gearbox.

Can a bush hog employee change a limited warranty?

NO EMPLOYEE OR REPRESENTATIVE OF BUSH HOG IS AUTHORIZED TO CHANGE THIS LIMITED WARRANTY IN ANY WAY OR GRANT ANY OTHER WARRANTY UNLESS SUCH CHANGE IS MADE IN WRITING AND SIGNED BY BUSH HOG’S SERVICE MANAGER, 2501 GRIFFIN AVE., SELMA, ALABAMA 36703. 2222222222222222222222222222222

How big is the rod on a 3308sh?

Mfd. by Monarch 2” Bore x 8” Stroke 1.125” Rod Dia. 3/4” –16 ORB Ports For 3308SH 8 7 1 12 13 3 15 6 5 2 12 4 10 14

What kind of gearbox does Comer use for the 3308?

50075003-TRANSFER GEARBOX ASSY (1:1.5) Mfg. by Comer For 3308-2 & 3308SH-2 Models REF. PART NO.