Are end fed antennas any good?

End fed wire antennas can work very well under many circumstances. They have some disadvantages, but with careful installation, they can work well and be particularly versatile offering multi-band operation.

How long is a 160 meter end fed antenna?

In fact, it looks more like an end-fed 1/4 wave 160 meter antenna (130 ft or 39.624 m long) which goes up some 25 feet (7-8 m), then over horizontally, at an average of 25 feet (7-8 m) above ground, to a tree at the far end of my property.

How long is a 80 meter end fed antenna?

The antenna has a limited bandwidth on the 80 meter band because the antenna is shortened for this band. The 10/(15)/20/40/80 End fed Antenna Kit has a total length of about 23 meters. From the feed point first 20.4 meter antenna wire then a coil of approximately 110 uH and then another +/- 2.5 meters wire.

How long is a 160m dipole?

As stated in the introduction to this article, the first biggest challenge for operating on 160m is the physical size of an efficient transmitting antenna. The length of a half wavelength dipole at 1.85 MHz is approximately 253 feet (each side would be about 127 feet).

What is an end fed antenna?

One of the most popular antennas today is the end fed antenna due to it ease of installation, portability and stealth in various installations. It can be a condo dweller’s only access to the world of ham radio or the best alternative for a backpacking SOTA (Summits on the Air) mountaintop expedition.

What is the best type of antenna for ham radio?

End Fed Antennas One of the most popular antennas today is the end fed antenna due to it ease of installation, portability and stealth in various installations. It can be a condo dweller’s only access to the world of ham radio or the best alternative for a backpacking SOTA (Summits on the Air) mountaintop expedition.

Where can I find assembly instructions for an end-fed half wave antenna?

The original assembly instructions are available from the manufacturer, HF Kits. To help new hams prepare for the exciting world of HF opening up during Cycle 25, ARRL has partnered with HF Kits to bring you this easy-to-build four-band antenna kit: an end-fed half-wave (EFHW) antenna.

What are the band compatibility options for end fed antennas?

The band compatibility options for the end fed antennas include high frequency and very high frequency. This ranges from 3 to 300 MHz. They tune at 10 Hz band intervals. The device compatibility options for the antennas include portable ham radios, fixed position ham radios, Zeppo systems, long-wire radios, and AM/FM radio tuners.