Why did my Worx trimmer stopped working?
Why did my Worx trimmer stopped working?
Try a replacement battery if they still don’t illuminate. If the replacement battery doesn’t work, the charging station may need to be replaced. Plug the charged battery into the trimmer. Press in the lock button, on the side of the rear handle, and depress the trigger.
What size string does the Worx trimmer use?
approximately 0.065”
And its diameter is approximately 0.065”, the same gauge that professional crews use. These spools fit the Worx 20V and 32V trimmers, and even the 40V 3.0 String Trimmer/Edger model, WG180.
How do I clean my Worx trimmer?
DO hold the trimmer’s cutting head level for straight, even cuts. DO inspect and clean the spark plug on gas trimmers each spring. DO keep an extra spool of cutting line on hand for when the trimmer runs out of line. DO brush the trimmer clean of all grass clippings after each use.
How long does WORX trimmer battery last?
about 20 minutes
The battery lasts about 20 minutes.
How long does WORX 40V battery last?
The battery last about 10 minutes, and that is being very generous! See attached photo! The edge on the right of the photo was done the day before. The Worx was on the charger each time a minimum of 24 hours.
Why does my line keep breaking on my trimmer?
Usually this is the result of the cutting head being taken too close to objects, e.g. garden stones, paving edges, walls etc. The cutting line must be allowed to rotate freely and the correct diameter and type of line should be used.
What is the difference between WA0004 and WA0010?
You can find spools that fit the WG124 here. What’s the difference between this and the Free Spools For Life package (WA0010)? This model (WA0004) is a two-pack of spools. Our Free Spools for Life package (WA0010) is a benefit for customers who have taken advantage of a special TV or internet offer from Worx.
Why do people take the guards off string trimmers?
If you decide to run a longer trimmer line, you need to completely remove the guard. If you only remove the blade, the trimmer line will get too long and get wrapped up in the guard. As the string wraps around the guard it increases the resistance on the engine and causes the engine to lose its power and RPMs.
Is it OK to leave Worx batteries on charger?
Always unplug the charger from the power supply when there is no battery pack in the charger or before attempting to clean.
Can you leave Worx batteries on the charger?
LEAVING THE BATTERY PACK IN THE CHARGER If a fully charged battery pack is left in the charger, the Light will remain green. The battery pack will remain to charge with a maintenance trickle current.
Can you use a 40V battery in a 20V tool Worx?
Worx Power Share™ uses one common battery to power every tool we make. So if you start off with a 20V drill, you can use that same battery to help power a 40V trimmer and an 80V mower. And a 40V Hydroshot. And a 20V circular saw.
How do I find my Worx model number?
The model number and serial number can be found on the rating label – See the below example.
- Warranty Statement.
- Terms.
- Product registration.
Where is serial number Worx?
Contact us. Serial Number The serial number can be found in a sticker either in the rear side or under the hood of your Landroid. You can also find it in the App.
