What can cause a P0345 code?
What can cause a P0345 code?
P0345 Causes
- A defective camshaft position sensor.
- Damaged or dirty reluctor ring on the camshaft.
- Defective, corroded, shorted camshaft position sensor circuit wiring.
- Defective, corroded, shorted camshaft position sensor circuit connector.
- A faulty crankshaft position sensor.
- Stretched or misaligned timing components.
How do I fix code poo16?
How to fix a P0016 OBD-II code?
- Repair the wiring or connections to the components, including the camshaft sensor or camshaft OCV.
- Check the timing chain and guides and replace if needed.
- Replace the camshaft OCV for bank 1 exhaust camshaft.
How do I fix code P0344?
What repairs can fix the P0344 code?
- Replacing a weak or dead battery.
- Replacing chafed, melted, or otherwise damaged wiring.
- Cleaning electrical connections to the camshaft position sensor.
- Replacing the camshaft position sensor.
- Replacing the crankshaft position sensor.
Where is sensor a bank 2?
Bank 2 Locations
| Vehicle | Bank 2 Sensor 1 Location |
|---|---|
| Hyundai Tucson | Radiator side of the engine, before the catalytic converter |
| Kia Stonic | Side with cylinder 2 in the firing order, on or right after the exhaust manifold |
| Land Rover Defender | Left-hand side, before the catalytic converter |
How do you fix a crankshaft position camshaft position correlation Bank 1 sensor A?
How To Correct P0016 Crankshaft Position – Camshaft Position Correlation (Bank 1 Sensor A)
- Use OBD-II scan tool and examine the code.
- If the camshaft sensor on Bank 1 is found faulty, it is needed to be replaced.
- Examine the wiring/connections to the camshaft OCV or camshaft sensor and replace if found damaged/worn out.
What does P0344 mean?
Diagnostic trouble code (DTC) P0344 stands for “Camshaft Position Sensor “A” Circuit Intermittent (Bank 1 or Single Sensor).” It triggers when the PCM detects a loss of signal from the Bank 1 camshaft position sensor. Bank 1 refers to the bank of the engine that contains cylinder #1.
What side of engine is bank 1?
Bank 1 and bank 2 simply refer to either side of the engine. Bank 1 is on the side with cylinder 1. Bank 2 is the side with cylinder 2. Most commonly Bank 1 is towards the front of the car if it has a transverse engine.
What is a camshaft bank 1?
Alternatively, if the engine employs a V configuration, the “A” typically refers to Bank 1’s intake camshaft. Finally, the “bank 1” in the P0341 code refers to the side of the engine where the number one cylinder is located.
Where is bank 2 sensor A?
Bank 2 Sensor 2 is the second sensor on the engine’s exhaust pipe, usually behind the catalytic converter.
How do you relearn a cam sensor without a scanner?
- Turn off all of the accessories.
- Accelerate the vehicle to 55 mph at part throttle.
- Cruise at 55 mph for another 5-6 minutes.
- Decelerate to 45 mph without using the brakes, and maintain 45 mph for 1 minute.
- Perform 4 deceleration cycles, without using the brakes, of 25 seconds each where no specific speed is necessary.
Where is the camshaft position sensor bank 1 located?
Beneath the timing belt cover is where the CMP Sensor is mounted. The camshaft position sensor can be found in the right side of the engine compartment at the rear of the valve cover.
