What amps do all that remains use?

All That Remains – Oli Herbert Guitar Gear Rig and Equipment

• Guitars. – Ibanez Xiphos Guitars (27 fret)
• Amps and Cabinets.
• Effects. – Maxon OD808 Overdrive. Also eyewitness reports say he has used an OD9.
• Strings, Picks and More.

What amp settings did Eddie Van Halen use?

To sound like Eddie Van Halen you will ideally need a guitar with a humbucker bridge pickup and tremolo system. Use an amp with plenty of crunch and sustain such as an EVH or Marshall or use an overdrive pedal through a clean amp. Other important effects include phaser, flanger, reverb and delay.

What was Kurt Cobain amp settings?

Nevermind Album Amp Settings. When the Nevermind album was recorded, Kurt Cobain used a Mesa Boogie . 22 preamp, a Crown power base amplifier, and 4×12 cabinets. For his distortion, he used a Boss DS-1 pedal.

What amp did Oli Herbert use?

EMG 81 Active Cermic Humbucker.

Did Kurt Cobain use reverb?

Apparently Cobain’s preferred amp was a 1960s Fender Twin Reverb, which he used to record In Utero, as well as MTV Unplugged. He also used a similar amp during the recording of Bleach, though it is unknown if it was the exact same one. He also favoured a Mesa/Boogie Studio .

How can I make my amp sound like heavy metal?

To achieve a good metal tone, have your amp settings on high for bass and gain, mid-low for the mids setting and mid-high for the treble setting. The key to achieving a good metal tone is high gain, high sustain and lot’s of low-end (bass). Remember, this is just a starting point.

How can I make my amp sound like the Beatles?

To sound like The Beatles on an electric guitar use either a tube amp which is cranked to the point where it starts to break up or use a solid state amp and set the gain to around 2-3. The EQ should favour mids and treble frequencies as opposed to bass frequencies.

How do you get the Nirvana sound?

To get Nirvana’s tone with your amplifier, have the treble and mids fairly high (around 7-8) and the bass on around 5 to begin with. The distortion should be quite high for the chorus (usually between 8-10), unless you’re using a pedal.

What tuning does Van Halen use?

Starting with their debut album, Van Halen used the E-flat standard tuning. It was around the late 1970s and the early 1980s that the tuning saw more use in rock music. I would call it the most common shredder tuning, but that’s debatable. Anyhow, the E-flat standard tuning is one semitone below the E standard.

What delay did Van Halen use?

The delays he used throughout his career were most prominently the Echoplex Delay, the Roland SDE-3000 Digital, and the Lexicon PCM70.

How do you get the Van Halen Brown sound?

Here’s how you get the signature Van Halen Brown Sound setting on a Phase 90: In summary, you need to set the Phase 90 at around 9 o’clock and add a subtle delay that is only just in the mix. In summary: set your pase 90 to 9 o’clock, and whack a touch of delay on and you’ve got the Van Halen sound of the first album.