Liverpoololympia.com

Just clear tips for every day

FAQ

Why is my Traxxas ESC not working?

Why is my Traxxas ESC not working?

You may need to reprogram the ESC for proper operation. Check the connector that plugs into channel #2 on the receiver to make sure that it’s tight. Test, replace, or Return the receiver to Traxxas for service.

Why is my Traxxas ESC blinking red and green?

A Traxxas ESC that’s flashing red and green is giving an over-voltage warning. It usually indicates the connection of an overcharged battery to the ESC. It can also happen when trying to use a NiMH battery if the ESC is in Low-Voltage Detection (LVD) or LiPo battery mode.

Why is my ESC not calibrating?

If it appears that the ESC’s did not calibrate then the throttle channel on the transmitter might need to be reversed. If you are still having trouble after trying these methods (for example, ESCs still beep continuously) try lowering your throttle trim 50%.

How do I manually calibrate my ESC?

Manual ESC-by-ESC Calibration

  1. Plug one of your ESC three-wire cables into the throttle channel of the RC receiver.
  2. Turn on the transmitter and set throttle stick to maximum (full up).
  3. Connect the LiPo battery.
  4. You will hear a musical tone then two beeps.
  5. After the two beeps, lower the throttle stick to full down.

What does a flashing green light mean on a ESC?

If the Low-Voltage Detection (LVD) is “ON” when a nickel-metal hydride (NiMH) battery is used an ESC may show the over-voltage alarm, indicated by a flashing red and green light.

How do I factory reset my Traxxas?

Place the throttle stick in the full down (throttle off) position and then press and hold any trim button to complete the reset. The red LED will begin blinking when the reset is complete.

What do ESC beeps mean?

First three beeps means that ESC is powered and activated. Then if the throttle signal is detect goes one long low tone beep. Then if throttle is zero goes one long high tone beep. This signal means the end of the start sequence and ESC is ready to run.

Why is my Traxxas blinking red?

Your Traxxas ESC blinking red may indicate thermal shutdown protection has kicked in to prevent overheating. Another possibility is that LiPo battery voltage is nearing its minimum discharge level.

Why do I need to program my Traxxas electronic speed control?

Your Traxxas electronic speed control may require periodic programming to maintain optimal performance. If your vehicle stops responding to throttle input, if you would like to change to a different mode, or if you switch from NiMH batteries to LiPo batteries you will need to go through these programming steps.

How do I contact Traxxas support?

Send us a message on YouTube! For immediate assistance you can reach us by e-mail at [email protected], or call 1-888-TRAXXAS (Monday – Friday from 8:30am to 9:00pm CT) to speak with a service specialist. Outside the US, call 972-549-3000.

What is the Traxxas support channel?

This channel covers maintenance, customization, troubleshooting, and much more to help you get the most out of your Traxxas vehicles. For additional resources, visit www.Traxxas.com/support, where you can browse support articles and check the community forum for tips and tricks from other R/C enthusiasts.

What should I do if my ESC is not working?

Try unplugging any other devices or servos that may be plugged into the receiver while keeping the ESC plugged into CH2. If you are able to calibrate the ESC, it is likely that one of the other servos or devices may be faulty.

Related Posts