Where is model number on a Hunter ceiling fan?
Where is model number on a Hunter ceiling fan?
Locating Your Hunter Ceiling Fan Model Number One is the outside of the packaging or the fan box’s lower corner if you still have it. The model number can also be found in the lowest corner of the user’s manual. Or you can check your receipt in your email if you purchased your fan online.
How do you reset a remote control fan?
To resync your ceiling fan remote, start by turning off your fan using the wall switch and then waiting for a few seconds. Different guides will tell you to wait anywhere from 10-30 seconds while the fan is off. After waiting, turn the fan back on again.
How do I identify my fan model?
You will find the model number for all fans on the:
- Part guide or installation manual that came inside your ceiling fan box.
- Outside of the box.
- On the fan itself. Location depends on the type of fan: For Downrod-mount fans- ID sticker located on top of the motor housing (facing the ceiling of an installed fan).
How do you date a hunter original ceiling fan?
The date code for your fan is a 4-digit number. For down rod mount fans, the date code will be on a sticker on the top of your fan’s body. For Low Profile fans, the sticker will be on the ceiling mounting bracket.
Where are the DIP switches on a Hunter fan remote?
The DIP switches are under the battery compartment on the remote and are on the flat side of the receiver.
How do I turn on my Hunter fan without a remote?
To turn it on without a remote, all you have to do is purchase a long pull cord to add to the pull switch, so you can operate it without struggling to reach the pull switch or even fumbling for the remote.
How do you test a DIP switch?
The DIP test allows you to verify the current settings of the DIP Switch on the Frame CPU board (4810AR-002). To confirm this test, you must remove the Frame CPU board to verify the setting of the DIP Switch.
Is there a reset button on ceiling fans?
There are several ways to reset a ceiling fan remote, but here’s the most straightforward: With the power off, hold down the button until the light on the remote flashes. Then, press and hold it again for 15-30 seconds to resynchronize the remote with your fan.
How do you date a Hunter ceiling fan?
Where is the serial number on a ceiling fan?
The Serial Number is only required if the product is a ceiling fan. The serial number is located on top of the motor housing. It will be a long number usually starting with V.
How old is my ceiling fan?
For down rod mount fans, the date code will be on a sticker on the top of your fan’s body. For Low Profile fans, the sticker will be on the ceiling mounting bracket.
How do you reset a dip switch?
Factory Reset using DIP Switches
- Raise Switch-1.
- Power the unit Off and On.
- Lower and Raise Switch-1 three times.
