What would cause a Maytag washer to not spin?
What would cause a Maytag washer to not spin?
One of the most common reasons for a Maytag top load washer not spinning is an incorrect wash cycle or spin setting. GENTLE, HANDWASH, or DELICATE settings utilize slower spin speeds for more fragile fabrics. Some model washers also allow you to vary the spin speed, making it slower or more rapid, for different loads.
What would make a Whirlpool washer not spin?
If your Whirlpool washer Not Spinning well, you need to check the pump. It could be clogged with debris or defective and needs to be replaced. To check the pump, disconnect the drain line and remove the back panel of your machine. Check for debris with a flashlight, or check with a special tool.
How do I reset my Maytag washer?
The easiest way to reset a Maytag washer is to disconnect the power to the washing machine for three minutes. Disconnecting the power allows the electrical charge to dissipate from the washing machine, which allows it to reset. If the reset fails, unplug the washer again, this time leaving it unplugged for ten minutes.
What would cause my washer not to spin?
The drainage is poor Normally, your washing machine won’t go into a spin cycle until it’s been drained. The drainage hose may become clogged with debris from your clothing, or it could be kinked. If the hose is kinked or crushed, it will likely need to be replaced.
What causes a front loader not to spin?
Front-load washer tubs spin thanks to a drive belt that runs off of the motor. A loose, frayed, or torn belt could be why your washer won’t spin. Overloading your washing machine can cause the belt to loosen or become worn out. Inspect the drive belt closely.
Why is my washing machine washing but not spinning?
Normally, your washing machine won’t go into a spin cycle until it’s been drained. The drainage hose may become clogged with debris from your clothing, or it could be kinked. If the hose is kinked or crushed, it will likely need to be replaced.
How do you reset the spin cycle on a Maytag washer?
Press and hold the Start/Pause button for 3 seconds. All indicator lights should be off at this point. Reset the Washer: To reset (clear) the washer, rotate the Cycle Selector Knob counter-clockwise (left) to clear any sequence.
What causes spin cycle to stop working?
If the spin cycle doesn’t work, the belt may be loose or broken. Tighten or replace the belt. 2. Check the lid switch and the tab on the lid that strikes it.
What is the most likely cause of a washing machine will not agitate or spin?
Common solutions for: My Washer Won’t Spin or Agitate. Inspect the drive belt to determine if it is broken or if it is loose on the pulleys. If the drive belt is broken or loose, replace it. The motor coupling connects the motor to the washer transmission.
How do you reset the spin cycle on a Whirlpool washer?
Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset. You can run a test load without any clothing to ensure that the reset worked.
How do I fix my washing machine that won’t spin?
- Redistribute an off-balanced load of laundry.
- Level an off-kilter washer.
- Check the power source.
- Stop using an extension cord.
- Inspect the spin switch.
- Stick to high efficiency detergent with a front-load washer.
- Undo any kink in the hose.
- Track down a blockage in the drainage system.
