What is the ratio of Vax carpet cleaner to water?

The Vax Ultra+ bottle recommends 40 ml per litre of water. The cap on the fresh water tank of my machine holds approximately 30 ml. I use four capfuls and add this and three litres of water to the fresh water tank.

How do you use a Vax machine?

Simply put Vax Pre-treatment Solution in the clean water tank, plug in the wand, turn on machine and it will produce a fine spray to put on the mess. Leave this on your carpet for 15 minutes and then begin your full carpet wash. Remember when it comes to stains, time is of the essence.

Do you dilute Vax cleaning solution?

If your Vax machine dilutes mechanically and has separate tanks for clean water and another for the cleaning solution, you should still dilute Dirtbusters Extraction Machine Chemical, mix 50:50 with water. E.g. if your solution tank holds 1litre of solution, you should use 500ml of solution and 500ml of water.

How much solution is in a carpet cleaner?

Carpet Cleaning Machine Mix 4 oz. Simple Green per ½ gallon of water into your carpet cleaning machine. Apply solution onto the carpet in sections. Agitate by gently brushing or scrubbing the area with a soft nylon brush.

Why isn’t my Vax carpet cleaner not picking up water?

Your Vax carpet cleaner may not be picking up water because the machine has picked up too much grime, and has become blocked up. Check around the head of the carpet cleaner for anything obvious that might make the suction on the Vax weaker, or look for clumps of hair that could be caught in the bristles.

Why is my Vax carpet cleaner not dispensing water?

IF NO WATER IS BEING COLLECTED FROM THE CARPET Check the seals are in place on the dirty water tank and that the tank is housed correctly and securely locked into position. Ensure the emptying cap on the dirty water tank is in place. Please check there is no damage to the front nozzle or dirty water tank.

Why is my Vax not picking up water?

How long does a carpet take to dry after using a Vax?

Vax Carpet Cleaners remove this build-up of dirt, odours and brighten the overall appearance of carpets. Even if you are short on time, with Vax’s quick dry technology in the Platinum Power Max, your carpets can be dry in just one hour, leaving your carpets clean, dry and smelling fresh.

Why is my Vax steamer not steaming?

Make sure this is initially set to the highest setting – you can always then reduce the velocity of the steam as you need during use. Ensure that your water tank cap is securely fitted. The cap on most cleaner’s tanks help to maintain the pressure and seal the steam in the unit, so need to be securely fastened.

Does a Vax carpet cleaner use hot or cold water?

warm water
Fill the clean water tank on your carpet cleaner with warm water and cleaning solution. Now you’re ready to go! Tip: always plan your route.

Do you have to rinse after using Vax carpet cleaner?

Rinse if you can If you have a carpet cleaner with a ‘rinse mode’ such as the Vax Platinum Power Max or Vax Rapid Power Advance, use this after washing with solution to remove any residue from the carpet, before allowing to dry normally.

How do you mix carpet cleaning solution?

To make a carpet softener solution, mix half a cup of fabric softener, one gallon of hot water, one cup of clear vinegar, and one tablespoon of dishwashing detergent. Put the mixture into a spray bottle, and lightly spray the carpet until it’s damp.