Should I put knobs or pulls on cabinet doors?

There are no strict rules to follow when choosing whether to select a knob or a pull or both. One preference is to use knobs for all doors and pulls for all drawers. For any large door such as a pantry and any pull-out door (including pull-out base pantries or trash pull-outs), use a pull.

Where do you put knobs on cabinet doors?

Cabinet knobs should be installed on the stile opposite the hinges. The general rule is to place a knob 2 1/2″ – 3″ from the corner of the door. For upper cabinets, install knobs in the bottom corners of the door. For lower cabinets, place them in the upper corners.

Where should cabinet door pulls be placed?

When it comes to installing cabinet door handles (either knobs or pulls), they are always placed on the opposite side from the door hinges. You’ll specifically want to place them anywhere between 1” and 4” from the top or bottom edge of the door.

Do knobs go on cabinets or drawers?

Traditionally knobs are used for cabinet doors and pulls are used on cabinet drawers however these days anything goes. You will often see people using knobs for drawers for consistency or based on the size of the drawers.

Are knobs or pulls more modern?

All Knobs or All Pulls More specifically, it is bar pulls that are sought after in modern designs, whereas vintage-style cup pulls are favored in farmhouse kitchens, or you can combine the use of both types of pulls in the same finish for a transitional style.

Can you mix pulls and knobs on cabinets?

Yes, you can mix knobs and pulls. It’s recommended to use pulls for cabinets that are higher up and knobs for lower style cabinets. Lower drawers that slide are typically fitted with a pull handle.

Where do you put knobs and handles on Shaker cabinets?

Center of the Stile: Knobs and pulls can be placed halfway up the stile of your Shaker door. Keep in mind you’ll want to be able to reach the handles, since they will be placed higher up along the stile. Just Above or Below the Corners: Place the knobs or pulls 2” to 3” from the lower or upper corner.

Can you mix cabinet pulls and knobs?

Should cabinet pulls all be the same size?

There is no right or wrong size to choose, but we do recommend choosing pulls that have at least a 3-3/4″ center to center (the distance between the screw holes). This size looks pleasing on most cabinets, while still being large enough to grip comfortably. 5″ pulls are also an excellent choice.

How do you measure for cabinet knobs?

To find the center-to-center measurement, use a screwdriver to remove your current pulls, then take a ruler or measuring tape and measure from the center of one screw hole to the center of the other screw hole.

What is the rule for cabinet hardware?

While there is no set rule, we generally recommend that the pull length is approximately 1/3 of the cabinet or drawer width. Small Drawers that are 12” or less typically work best with a pull that is 3” to 4” long or a knob that is 1” in diameter.

Should I use all pulls on kitchen cabinets?

All Knobs or All Pulls If you would like your kitchen cabinet hardware to look homogenous then you should place all pulls or all knobs on your cabinet doors and drawers.