How many watts is a Fender Tremolux?

The Fender Tremolux was a guitar amplifier made by Fender. It was introduced in the summer of 1955 with a rated power output of 15 watts, cathode bias, two 6V6 output tubes, and a 5V4 tube rectifier. The Tremolux was the first Fender amp with a built in effect, tremolo.

What is AB763?

‘AB763’ was Fender’s internal model designation for the 1963 blackface circuit. “Blackface” refers to the panel color and 763 means July 1963. The circuit was used in the Deluxe, Deluxe Reverb, Twin Reverb, Super Reverb, Band-Master, Showman, Pro, Vibrolux, Vibroverb and Tremolux.

What is the Fender Blackface sound?

Out of Blackface, the classic “glassy” Fender sound was born, and Blackface amplifiers quickly became famous for their clean detailed sound a low volumes, increased headroom, and smooth overdrive when cranked to higher levels.

What circuit is the Deluxe Reverb?

The Deluxe Reverb is a 22-watt tube amplifier (at 8 ohms), powered by a pair (“duet”) of 7408/6V6GT power tubes, one GZ34/5AR4 rectifier tube, four 7025/12AX7 tubes for preamplification and tremolo oscillation, and two 6201/12AT7 tubes driving the reverb and phase inverter circuits.

What is a Brownface amp?

The Brownface was a 15W amp with tremolo bias wiggle on-board. Additionally, it was fitted with larger 10-inch speaker and was the first fixed bias Princeton. This design used a cathodyne phase inverter which is circuit that was found in 5E3 Tweed Deluxe and many other amps of day.

How long do Deluxe Reverb tubes last?

In a closet, the tubes will last forever, of course. For practice in a bedroom a couple of times a week at modest volumes, you’ll probably get five to ten years out of them.

Who used a fender bandmaster?

Pete Townshend used a 1959 Fender Bandmaster amplifier with his Gretsch 6120 Chet Atkins Hollow Body to create the rich feedback-laden sound heard on virtually all studio recordings beginning with Who’s Next in 1971.

What is the tweed amp sound?

‘Tweed sound’ has become a bit of a byword for a particular type of tone. For most of us, it means old-school overdrive with fat mids, slightly loose lows and clear treble that falls somewhat shy of the shrill glassiness you can sometimes get with later Fender designs.

Which amps are blackface?

Probably the most commonly seen of the Fender amps (in both original and reproduction form) are those of the Blackface Era. Production of these amps started in 1963 and carried on until around 1967, with a few amps still being produced this way into 1968.

What artists use a deluxe reverb?

It has appeared on thousands of albums over the years and has been played by, not only blues guitarists but rock, country, and funk players of all kinds. The Beatles used it on many albums in the late 60’s. Fender claims the Deluxe Reverb is the most recorded amp in history.

When did Fender switch to Silverface?

1968
In 1968 Fender changed to the “silverface” control panel. The circuitry was altered as well: There were changes to the bias and phase inverter circuits and, most important, the output stage.

What is a blackface amp?

Blackface amps are a mainstay of many guitar rigs. Favored by club players who typically use a Princeton, Deluxe or Vibrolux, they are known for their clean sounds and slightly driven bluesy tones. They are also a fantastic platform for pedals. The larger ones have been used by many famous guitarists.

How often should a tube amp be serviced?

That should read “regularly, as a part of normal service, approximately every 15 years”. It does not matter if the amp’s been played or not – in fact, stored amps need them replaced more frequently. And they can fail with NO audible or visible warning, taking out expensive parts – like power transformers.

What amp did Eddie Van Halen use?

This tone is pretty simple, Eddie Van Halen used his legendary Marshall Plexi amplifier famously cranked to the hilt with every knob turned up to 10 (or 11!) and his iconic Frankenstein guitar with the single humbucker in the bridge. The reverb and room mic effects mixed in also have an influence on this recording.

How many watts is a Fender Bandmaster amp?

It produces 40 watts into 4 ohms.

What is the Fender AB763?

From a modern perspective the AB763 amp circuit is a benchmark which set the Fender standard so high that all of the following circuit changes failed to significantly improve the design. Most Fender aficionados consider the AB763 circuit to be the Fender high water mark.

Do all AB763 amps have tremolo?

All of the AB763 amps have tremolo and some also have spring reverb. Most of the model differentiation comes from the power supply, the number of preamp stages, FX, power tube type and number, output transformer and speaker configuration.

How many amps does an AB763 deluxe reverbpower transformer use?

So a AB763 Deluxe Reverbpower transformer must supply at least 1.9 amps of 5V rectifier heater current, 2.7 amps of 6.3V current for the tube heaters and 92.7 milliamps (0.0927 amps) of B+ current. It uses 9.5 watts of 5V, 17 watts of 6.3V and 38.7 watts of B+ for a total of 65.2 watts, less than a 75 watt light bulb.

What are the jumping channels in The AA763 Tremolux for?

Jumping channels in the AA763 Tremolux can give you a wider spectrum of tones than by using just one channel. You may for example use the normal channel to deliver the bass tones and the vibrato channel for sparkling clean sound with bright switch on and zero bass.