How do I fix error code F02 on Whirlpool?

Press the pause or cancel button on the Whirlpool washing machine to clear the F02 error code from the display, and try using it again. The error code is displayed when the washer takes more than eight minutes to drain, but may just be a glitch.

What does the code F02 mean on Whirlpool washer?

a long drain time
The F02 error code on a Whirlpool washer indicates that the control detects a long drain time. This can be caused by excessive suds in the tub, a restriction or clog in the drain system, or by a number of other component failures.

How do you reset your Whirlpool Duet washer?

Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset. You can run a test load without any clothing to ensure that the reset worked.

Does the Whirlpool Duet washer have a reset button?

The easiest way to reset the whirlpool duet front loader computer is by unplugging the washer for 30 (or so) seconds. Quick Tip: Feel free to repeat the procedure a couple of times if it won’t work the first time.

Why does my oven keep beeping and F2?

If your General Electric oven is displaying the F2 error it could be just a glitch or it could be indicating that a component needs to be replaced. It can appear when you are baking or while the oven is in “Cleaning Mode.” When this error code does appear the oven will be unusable until the problem is resolved.

How do you fix F2?

If there is a blockage, it can cause the oven to overheat and trigger the F2 error code. Oven fans can also be affected and should be checked for a blockage or a fault. Cleaning the oven with some vinegar or baking soda and checking and clearing the ventilation and fan may resolve the error code.

Is there a reset button on a Whirlpool washing machine?

Follow these steps to reset a Whirlpool washing machine: Make sure the power to the washer is turned on at the wall, but keep the Power button on the control off. Hold the Program button down while simultaneously pressing the Water Level button two times. When done correctly, the control panel lights should illuminate.

How do you reset a front loader washing machine?

Unplug the washer and let it sit for a minimum of two minutes, preferably five or ten. This will give residual water in the pipes a chance to drain out. Re-plug the washer and push the start button. It will run through a short cycle and then shut off again.

What does F2 mean on a washing machine?

Washer does not drain or spin.

How do I fix the F2 code on my oven?

Once you have located the control board, examine the control board for signs of damage. If the control board is noticeably damaged, replacing the control board should resolve the F2 error code.