Can you use flexible gas line water heater?

These straps prevent a water heater from tipping over and are required in earthquake-prone areas. $12 per pair. A flexible gas line can withstand movement and is usually required in earthquake-prone areas. They’re easier to connect than steel pipe, but they’re not allowed everywhere, so check with your inspector.

Are 80-gallon water heaters still made?

The gas hot water heaters are still available because the makers could make changes to the tanks that brought them into compliance. The 60, 80. and 100 gallon tanks are not efficient enough to meet the new energy requirements.

What size should supply line to water heater be?

“Most homes will need 3/4”. Some of the older houses in town, though, piped the entire hot water system in 1/2”, to get the hot water faster and cut down on waste.”

How many amps does a 80-gallon water heater pull?

Meanwhile, an 80-gallon heater powered by 5500 watts and 240 volts, will result in 5500W/240V x (1.25 continual load) = 28.64 amps. Meaning, a 30-amp dedicated circuit breaker is enough.

What does an 80 gallon hot water heater cost?

between $1,000 and $4,000
80-Gallon Electric Water Heater FAQs Your costs will vary, but you should typically expect to spend between $1,000 and $4,000 on a water heater this size. Heaters with lower price tags generally offer fewer features than their more costly counterparts.

What does an 80 gallon water heater cost?

$1,000 to $3,000
A 30-gallon tank-style water heater runs approximately $270 to $900, and an 80-gallon tank ranges from $1,000 to $3,000.

Does a water heater need 3/4 pipe?

Water heaters have 3/4″ connections to allow for increased flow and pressure where it’s needed and where the pipes are larger, but that doesn’t mean your plumbing has to match. The heater will flow at the same rate (more or less) as a straight run of 1/2″ pipe in your case.

What size water line do I need?

In the case of a three family house an 1 1/2″ service line is typically required. Again the exception would be if the length of the run of pipe was only 35′ or less. In most cases a six family house or greater will require a 2″ water service line.

Does a gas hot water heater need a dedicated circuit?

A tiny amount of power is all it takes to ignite the flame. Unless the manufacturer requires it, there’s no need for a dedicated circuit.

What size breaker do I need for a gas water heater?

Usually, it’s about 12 amps and less than 120 volts. Gas tankless water heaters need a minimal amount of electricity to power the electronic ignition system. A gas tankless water heater only needs a 15-amp, 120 volt dedicated single-pole breaker for this purpose.

Can you install your own water heater?

Installing a water heater is no average DIY project. You must have plumbing, electrical, heating ventilating, and carpentry skills, know state and local building codes, obtain a permit for the work and arrange with your municipality for an inspection of the work.

What type of pipe is used for water heaters?

CPVC pipes
CPVC pipes are an ideal choice for hot water plumbing. They are made after adding material that goes through extra chlorination process which gives CPVC higher quality.

Is it safe to install a gas water heater yourself?

If you’re planning on installing a gas water heater yourself, you should know that there’s a significant safety risk in doing so. Improper installation can lead to serious injury. If the temperature of the tank is off or if the pressure relief is unable to function due to improper installation, an explosion can occur.

How difficult is it to install a gas water heater?

Gas water heater installation may seem like a job for the pro’s, but actually, it’s not as difficult as you may think. Certainly, the easiest way to get the job done is to hire a professional to do the work for you.

How long does it take an 80 gallon water tank to heat up?

A large 80-gallon gas water heater takes about 60 to 70 minutes to heat up.

Do I need a 50 or 80-gallon water heater?

For 1 to 2 people: 30-40 gallons. For 2 to 3 people: 40-50 gallons. For 3 to 4 people: 50-60 gallons. For 5+ people: 60-80 gallons.

Can you run PEX straight to water heater?

Can I Connect PEX to My Water Heater? PEX can’t be directly connected to a water heater.