How do I unlock my Sundance Optima?
How do I unlock my Sundance Optima?
LOC Hot tub control has been locked by pressing the DISPLAY, MODE and (up) button within 3 seconds. Press DISPLAY, MODE and (down) button within 3 seconds to unlock panel.
What does the red light mean on a Sundance spa?
immediate attention
The indicator light located on the front cabinet panel of the spa is an early detection system that will notify you when the spa needs immediate attention. A solid white light indicates that all operations are normal. A solid red light indicates that immediate attention is required to clear or fix an error code.
What mode should I keep my hot tub on?
By default filter modes are 2 hours in the morning and 2 hours in the evening, the rest of the time the hot tub will use the insulation to keep the spa warm and retain heat. Economy is a good setting for those who use the hot tub daily.
Why won’t my Sundance spa heat up?
Low flow in your spa or hot tub is most commonly associated with a dirty spa filter. If your spa heater won’t heat, remove and clean the filter(s) to rule out a pressure or flow rate problem. Low water level, a clogged pump impeller, closed valves, clogged pipes, or blocked spa drain covers can also cause flow issues.
How do I restart my hot tub?
Let’s look at how to restart your hot tub if you haven’t used it in awhile.
- Turn Off the Power. Before doing anything, you want to turn off the power to your hot tub.
- Drain Your Hot Tub.
- Flush Your Hot Tub Jets.
- Clean Your Spa and Your Cover.
- Clean Your Spa Filter.
- Let Your Spa Dry.
- Check Your Wiring.
- Refill Your Hot Tub.
How long does it take for Sundance spa to heat up?
Close the hot tub cover to allow the spa to heat and avoid any debris from entering the hot tub. Let your hot tub heat up for at least 5 hours.
Why is the light blinking on my hot tub?
If the hot tub is not heating, the light is blinking because the water temperature has dropped more than 2 degrees from the set temperature.
Why is my hot tub control panel flashing?
It also provides a diagnostic function–a flashing power indicator indicates that the heater high limit has tripped, meaning that either the spa water is above its acceptable temperature range, or a malfunction has occurred within the spa (such as low circulation due to clogged filters).
How do you program a Sundance spa?
Press the “Menu” button and Select “PF” to display the current start time. Press the temperature up or down buttons to adjust start time. Press “Jet 1” to confirm and activate desired start time. Next, use temperature up or down buttons to adjust the number of cycles per day (1-4).
Why is my hot tub not reaching temp?
If your hot tub fails to reach the temperature you’ve programmed into it, then the heater is not working properly. It could be the heater element, it could be a temperature sensor, it could be flow switch failure or any one of a dozen other reasons.
Should Jets be on when heating hot tub?
Before covering your hot tub, make sure to turn on the jets as this will accelerate the pace of your hot tub’s heating. By running the jets, you’re allowing the heated water to be circulated and evenly distributed to all areas of the hot tub.
Is there a reset button on a hot tub motor?
There are generally two “hard resets” in hot tubs, the GFCI, and the high limit reset. The GFCI pops if there is any type of electrical short (such as water getting into the heating element, the reset on that can be in one of three places.
Where is the spa heater reset button?
Locate the spa’s high-limit reset. This is a red button found on many spa packs. It may be located on the heater and covered by a rubber nipple.
What temperature should I leave my hot tub on overnight?
Knowing that hot tub water heats up around three to six degrees per hour, keeping it as low as 10° less can still be fine. At most, it will take about 3 hours to get back to normal when you’re ready for it. But if you find your hot tub heats slower, or you don’t like waiting, keep it at 5 degrees less instead.
Do You Enjoy Your Sundance Optima?
We enjoy it on a daily basis so far with the weather. Recommend Sundance for anyone looking for a hot tub that has all the features, affordability and luxury needed.” “Before we purchased our Optima spa we traveled to different spa dealers and wet tested other spas. The Sundance Optima was our choice.
How do I order a Sundance® Hot Tub?
Our hot tubs are built to order and delivered through your local authorized Sundance® Spas professional, who will contact you directly to arrange delivery details. You can expect a phone call to confirm transport details and to establish a date and time to set up your new hot tub after the order is placed.
What kind of manual do they use for hot tubs?
(2020) 780™ Series Manual – (Chelsee®, Hamilton™, Montclair™, Bristol™, Hanover®, Dover™) (2020) 680™ Series Manual – (McKinley®, Ramona®, Edison®, Peyton®, Prado®, Denali®, Tacoma®, Alicia™) “We have had our hot tub now for about a month.
What can I expect when I order a hot tub?
You can expect a phone call to confirm transport details and to establish a date and time to set up your new hot tub after the order is placed. Contact information will be included in your order confirmation for any questions leading up to delivery.
