Are Ford 8.8 rear ends strong?
Are Ford 8.8 rear ends strong?
Ford 8.8 Strength ComparisonThe truth is that the Ford 8.8 is virtually a clone of the Chevy 12-bolt and therefore almost as strong. Most rear axles are described by their ring-gear diameters, with larger being better.
What gear ratio does a Ford 8.8 have?
Ford 8.8 Inch 3.55-5.13 Ratio.
Is a Ford 8.8 rear end limited slip?
Ford 8.8″ 10 Bolt, 28 spline, 1979-Current. Limited-Slip-to-Locked, Select-able Locking Differential. Limited-Slip-to-Locked, Select-able Locking Differential.
How do I know if my limited slip differential is working?
The easiest way to tell if you have an open differential is to jack up the car and spin one of the rear tires. If the other wheel spins in the opposite direction, you have an open differential. If it spins in the same direction, you have a limited slip differential, or LSD.
How much horsepower can a 8.8 Ford rear end handle?
Dead stock (31 spline version, which is what the Explorer has) it can handle up to about 400 rwhp as long as you’re not on DR’s or Slicks.
Is Ford 8.8 a good axle?
Although not serving up the same beef as the respected Ford 9-inch, the slightly smaller 8.8-inch has held its own as a good medium-duty wheeling axle, especially when used on lighter rigs. The axleshafts have been available in 28- and 31-spline counts.
Can you put 5.13 gears in a Dana 30?
The tire size for 5.13 gears would probably severely overstress the Dana 30…
What does a worn differential sound like?
A whine during deceleration may mean there is a bad or loose pinion bearing. A howl during acceleration may indicate the same problem. Rumble or whining sounds only at speeds greater than 20 mph could be a sign of a worn carrier bearing. The sound may change while cornering.
How do you tell if your diff is broken?
5 Signs of a Failing Differential
- Tire Damages. If you notice strange damages on the sidewall and outer tread of your vehicle’s tires, it may be caused by failing differential components.
- Hard to Handle.
- Vibrations.
- Gears Grinding.
- Whining Sounds.
How long do limited slip differentials last?
Most regularly driven rigs should need the rear differential rebuilt after reaching 100,000 miles. Those that see a mixture of sand, dirt, gravel, and snow or are used for towing or off-pavement duties will probably need the limited-slip rebuilt before 60,000 miles.
How do I identify a Ford 8.8 axle?
The 8.8-inch pinion shaft is 15/8 inches and has 30 splines. A Ford identifying tag is attached to one of the rear cover bolts. The four-letter code on the top right of the tag will be a dead giveaway as to whether you have found an 8.8-inch axle.
What are the lowest gears you can put in a Dana 30?
Registered. Dana 30 and Dana 35 carrier break is 3:54 and numerically lower, 3:73 and numerically higher….
What gears will fit in a Dana 30?
Description: DANA SPICER 706008X : Fits Dana 30 axle with 3.73 gears or numerically higher. Commonly referred to as a 4 series carrier.
How do I know if my differential is going bad?
Here are the most common bad differential symptoms to look out for:
- Your vehicle is quickly going through oil.
- Difficulty steering.
- A loud front differential noise, such as the grinding of gears, clunking, or a “howling” sound.
- Rear differential noises.
- Extensive and inexplicable wear and tear on your tires.
