How do I delete a user code in Vista 20P?

Remembering the 2 digit user number is very important if you need to delete a user code. To delete a secondary code, do the following: [Master Code] + [8] + [User Number] + [#] + [0]. You will receive a short confirmation beep letting you know the code has been deleted.

How do you delete a user on alarm com?

Delete User Codes using Customer Website:

1. Log into the Alarm.com Customer Website.
2. Click Users.
3. Click to select the user to delete. To delete the entire user: Important: If there is contact information associated with the user, it will also be removed. Click Delete User.

How do you reset the master code on a Honeywell alarm system?

How to change the master code of a Honeywell Alarm system

1. Press 8 (the CODE key).
2. Press 02.
3. Enter a new four-digit master code.
4. Re-enter the new code. The keypad will beep once to let you know that the code has been changed.

How do I reset my Honeywell Vista 20P?

To Factory Reset the Honeywell Vista 20P: 3) Press and hold * and # for three seconds on the programming keypad from there you should see INSTALLER CODE 20 or 20. 4) Press *20 4112 (You should hear 3 beeps) this will indicate that you have successfully reset your Honeywell Vista 20P.

How do I change my master account on alarm com?

TO CHANGE EXISTING USER/MASTER CODES:

1. Follow steps 1 & 2 as above.
2. Select the user from the list that you wish to update.
3. Tap on the current user name to change name details, then select save.
4. Tap on the current user code, enter new 4 digit code, then select save.

How do you reset house alarm code?

Follow these steps to replace the backup battery and reset your house alarm:

1. Locate the “System” or “System Status” button.
2. Open the control panel.
3. Remove the backup battery.
4. Switch the circuit breaker off and on.
5. Replace the backup battery.
6. Input your user code.

How do you reset the house alarm code?

How to reset a house alarm after a power cut?

1. Locate the “System” or “System Status” button. On your home alarm keypad, find the “System” or “System Status” button.
2. Open the control panel.
3. Remove the backup battery.
4. Switch the circuit breaker off and on.
5. Replace the backup battery.
6. Input your user code.